SAME DAY SHIPPING ON ORDERS PLACED BY 4 PM | 877-4-SPRUCE

Amber Rocker Switch 14-307

$9.85/Each
Part# 14-307
MFR Model# 14-307
DescriptionColorVolts/AmpsPart Number
Illuminated Rocker Switch OFF-ONAmber12v / 20 amps14-307

Overview

Illuminated Single Pole Rocker Switches, OFF-ON, 12V / 20A
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Very functional for daytime, a little too bright for night flight.

L W
March 10, 2014

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What are the dimensions of these rocker switches? What is the amperage rating? Will these illuminated rocker switches act as both ON-ON switches, and ON-OFF switches?

The dimensions of the switch faceplate is approximately 1-1/4" x 3/4". Total depth of switch from top of switch to bottom of terminal is approximately 1-1/2". These are 12V / 20 amp switches. They are intended to be used as ON-OFF switches only, not designed for ON-ON.

Q: Are these rocker switches TSO'd?

No, for use on experimental aircraft only.

Q: Are these switches designed so that they push up for on and down for off?

Yes, these switches are designed to be up for on and down for off.

Q: How wide is the spade connection on this switch? They are typically either 0.25 or 0.187.

The spade connection is .25" wide.

Q: Are these Rocker Switches illuminated by LEDs?

No, the bulbs are incandescent.

Q: What are the dimensions for the panel hole?

The panel cutout needs to be 1.12" (28.5 mm) in height, and .55" (14 mm) wide.

Q: I note that there are 3 terminals on the switch. Are they : source, load and ground?

Yes you are correct. This switch is as follows: 1. 12V
2. Load
3. Ground

Q: Are these switches LED or incandescent?

These are incandescent.

View in Catalog

View Image View in Catalog