FREE SHIPPING ON ORDERS OVER $350 (SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

Piper Wing Root Seal - Rubber - 12 Ft

$52.75/Each
Quantity
Add to Wishlist
Part# 05-00030
MFR Model# JMWRS1

Overview

Available in black and packaged in 12 foot lengths.

Adequate for one wing root.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Joseph F Verified Purchase

Piper Wing Root Seal 12 Foot Piece

December 7, 2022

Perfect fit

Timothy L Verified Purchase

Piper Wing Root Seal 12 Foot Piece

July 26, 2022

I wish there were reviews when I purchased this wing root seal. I put it out in the sun to loosen up the stiffness..it helped, a little. Do not buy this one, it is too stiff. Maybe get one of the others offered.

John W
September 23, 2023

This stuff is vinyl, not neoprene rubber that Piper uses. Do not buy this product!

Mark B
August 2, 2023

If you have a Piper Cherokee (PA-28) that needs a new wing root seal do NOT use this product. It is nearly impossible to install - it is much thicker than the original factory installed wing-root seal - and worst of all it wont last. I purchased and installed this product in 2016 - it took me almost five hours to install it on just one wing because the material is so thick I had a horrific time getting it to slip into the gap. Several weeks later I noticed it was already crazing in certain areas, in particular around the leading edge area of the wing root. After about 14 months it started to split in several areas. The interesting thing is that my ship is always hangared. If you need a wing root seal for your Piper Cherokee get the other one that is offered on AS, Part # 05-13058. That one is identical to the factory installed version.

Roman S
October 12, 2017

Totally worthless. Difficult to install and is rotten and falling off my PA38-112 - cant fly until replaced. Just a little over a year old and parked most of the year in a shade hangar.

Jerry H
March 24, 2018

This wing root seal does not last. Airplane is based in Florida and is tied down outdoors. In less than 2 years, the seal is COMPLETELY DETERIORATED. The other side is an original that is nearly 30 years old and this new replacement looks even worse than the old one that I replaced. JUNK MATERIAL, do not waste your efforts to install this junk!

Ugi
May 16, 2016

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Does this require an adhesive? My A/P broke the pilot side. It looked like it had glue of some sort under it.

We do not supply any specific for this. Adhesive is not normally used, it is a press fit application. Adhesive can be used if the applicators feels it is necessary.

Q: Can this be sold in any shorter lengths?

No, these are only sold in 12 foot lengths.

View in Catalog

View Image View in Catalog