Aircraft ID plate for factory built or experimental, made of aluminum. Not FAA Approved. Engraving included. When ordering please provide: Make, Model, S/N, N#. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The size of both the factory built and experimental ID tags is 1" X 3".
This is made of Aluminum and not Stainless Steel. The thickness would be .025".
These do have a strong adhesive back, but an end user could drill the corners and rivet it on if they like.
These do have a strong adhesive back, but an end user could drill the corners and rivet it on if they like.