All amateur-built aircraft must have a nameplate. Etch or stamp required data on this indestructible stainless steel nameplate. Conforms to FAA requirements. Size: 3” x 4-1/4”. Attention: Engraving is not included or offered for this nameplate. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Just what I needed
Experimental Nameplate Ss
Never wares out 👍🇺🇸
Experimental Nameplate Ss
Experimental Nameplate Ss
Very good
Experimental Nameplate Ss
As advertised
Experimental Nameplate Ss
perfect!
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, this particular nameplate cannot be engraved by us. The easiest place to take it to engrave would be a local trophy shop. If you would like it engraved by us, part number 09-40000 would be your best bet.