Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Del Fitting Seal 5/8 OD Aluminum
MFR Model# DY90-A-10
FREE Shipping
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
| Tube Size O.D. | Fitting Dash Size | Part No. |
|---|---|---|
| 5/8 | 10 | 04-05010 |
Overview
| DEL fitting seals are designed to eliminate leakage due to scratches on the sealing surface, improper torquing, or poor finishes on tube ends, in high or low pressure applications. For use with AN, MS, and JIC 37° flared fittings, DEL fitting seals also reduce tube flare cracking by reducing torque needed, eliminating nose damage to the fitting, and allow reuse of hardware. Approved by NASA, SAE, Air Force, Army, Navy, and major aerospace contractors. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Reviews
Verified Purchase
Del Fitting Seal 5/8 OD Aluminum
These seals are amazing! Instead of replacing lines and fittings in a very tight engine space, these sealed the damaged AN fittings perfectly.
Verified Purchase
Del Fitting Seal 5/8 OD Aluminum
Fast service as always! You and mcmaster carr are the best
Works perfectly
A little oil leak goes a long way down the belly of an airplane. This little seal stopped the leak and gave me a little more piece of mind about my oil pressure situation.
Fantastic product. My guys use these in the US Air Force. We decided to try on our civilian GE LM6000 engine and they worked great. Prevented having to spend several thousand dollars for a new GE part.
If you are working with AN fittings I agree you should have some of these in hand. I was doing an efi conversion in a car and two expensive 90 degree fittings were leaking. Ordered these and some extras, I put it in the fitting, connected it all and that was the end to those pesky leaks. Highly recommend them.
worked as advertised. Stopped small fuel leak immediately
Ordered these for replacement on AN fittings after fuel system repair. They are extremely fragile and I was unable to get one into proper position without damaging it. Finally put the system together without the fittings and it worked fine, no leaks.
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
They are aluminum.
These are priced and sold individually.
These can be used with both steel and aluminum.
Copper is recommended by the manufacturer.
