For Starduster or Skybolt. Flat Gray finish, 18" wide. Can be upholstered or used plain. Contoured bottom for parachute. These are not chopped glass seats. Hand layed up for extreme lightness. Wt. 3 lbs. 10 oz. Note: This oversized item ships in a 21 x 21 x 21 box with a dimensional weight of 48 lbs. (56 lbs internationally) |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
We do not have a mounting kit for this seat. Mounting brackets would need to be fabricated for each application.
Dimension are as follows: Width 18", Height 21", Depth 16"
Per the manufacturer: The weight is approximately 4.4 lbs. We are not able to provide the angle of the seat bottom.
No, there are no pre-cut holes in the bucket seats. These would need to be added later by the installer.
There are no attach points at the bottom of the seat. Mounting brackets would need to be fabricated for each application.
These are fiberglass seats.
Outer edge to outer edge is 18", the seat portion where you sit is 16" wide.