C-200 Wraps ties from 18 to 50 lbs with auto tension setting & a rugged die cast aluminum body. Applies traditional ties as well as low profile ties. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
POSSIBLY THE WORST TOOL I HAVE EVER PURCHASED. DOES NOT PULL TIES PROPERLY. DOES NOT CUT TIES IN THE APPROPRIATE LOCATION. DOES NOT CUT TIES FLUSH (LEAVES A SHARP EDGE AS IF CUT WITH DYKES). TRIED TO ADJUST THE TENSION AND THE TOOL LOCKED UP. LOOSENED THE ADJUSTED AND NOW THE TOOL REQUIRES TWO HANDS TO OPERATE. COMPLETE WASTE OF TIME. BOUGHT A TOOL AT ADVANCE AUTO AND IT WORKS MUCK BETTER.
This tool is an absolute piece of junk! The knife cuts 1/2 inch long every time. And adjusting the tension causes the tool to break the tie wrap before being cut. Save your money, and buy something else.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.