1/16" Solder Stop Swage for use with throttle/choke inner control wire. Must be properly peened and dip soldered to create a secure bond. Requires solder pot. etc. Fits Mikuni and Bing Carb slides and choke plungers perfectly. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
1/16 Solder Swage
1/16 Solder Swage
Item is good but you don’t need and fancy welding pot to use just heat up silver solder on a spoon put your flux on dip it in and that’s it
1/16 Solder Swage
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, the 1/16" is the hole diameter.