AWG Size | Stud Size/ Insulation | Part No. |
---|---|---|
4 | 5/16 | 33470 |
AMP® Battery Terminals AMPs not listed, AMPs are only determined by wire being used. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Amp Battery Terminals 33470
Are well made. You will need a method of making a good crimp. They are tinned so soldering should be uneventful provided you use good flux and lead content solder with enough heat.
Amp Battery Terminals 33470
Wonderful stuff!!!!
Wonderful stuff!!!!
Thanks for rapid response.
Works great.
Top notch , very good quality !
I used these and they are high quality. Not sure whats with the 1 star review someone else left but I am ordering more right now because I liked them
Good terminals. Make sure you get the proper size hole as they are hard to enlarge. I had the 4 gauge size in 1/4 and had to drill them out to 3/8 terminal size. It can be done, but it is not all that easy.
As advertised worked great
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this will work with 2/O wire.
Yes, these are tinned copper.
We only carry these that are tinned copper and a regular copper version.
These connectors are intended for crimping. Part # 12-03719 or 12-03178 will work.