The ball bearing windsock frames are a rugged design constructed of a welded steel construction and then a powder coated finish for corrosion protection. They incorporate a two bearing pivoting design for effortless pivoting. These frames are ready to be mounted on a 3/4” female pipe thread for the 8”, 13”, 18” and 24” and a 1” pipe thread for the 36”. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
This wind sock is a very strong ,wonderful product.
Aws Ball Bearing Frame 18
Excellent
Aws Ball Bearing Frame 18
Well made at a very reasonable price. Ordered the 72 inch sock to go with it.
Aws Ball Bearing Frame 18
Well made and works well with the ball bearings
Aws Ball Bearing Frame 18
Excellent product. Would recommend to everyone.
Aws Ball Bearing Frame 18
Aws Ball Bearing Frame 18
Product shipped quickly and is as described.
Aws Ball Bearing Frame 18
This replaced a product that we used for decades, good quality.
Aws Ball Bearing Frame 18
Very satisfied with this product.
Well built and easy to install, we mounted it on top of a carbon fiber pole on the roof of our sun-shelter. We are a RC Flying club. www.wimca.ca
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it would work with standard 3/4" plumbing fittings.
FAA type L-806 support - those mounted on low mass supporting structures - maximum of 3.0 m (10 ft) mast height. brbr FAA type L-807 support - those mounted on rigid supporting structures - Maximum of 4.8 m (16 ft) height to windsock.
Unfortunately we do not offer any custom embroidery on these wind socks. We only sell them stock, it would need to be embroidered post receipt.