Nelson Piper blade pitot cover with white letter REMOVE BEFORE FLIGHT on red banner. Note: If the plastic is cold, it may be a little stiff, but should conform once it is on the pitot tube. It may help to warm up the molded part first, with a hair dryer or soaking it in hot water, then it should adapt to the tube. After it has been used a few times, it will probably take a "set" and retain the shape enough to make the installation easier. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Works great on the pitot blade for a PA-32-300
Nelson Piper Blade Pitot Cover
Fits great, works as advertised.
Fits well on a piper pitot blade. Just have to give it a little squeeze.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The ID is 1-1/8"