The abrasion boots are placed on the leading edge of the horizontal stabilizer. The boot is applied to the Left & Right Stabilizer Abrasion.
Note: Per aircraft, a quantity of two boots needs to be applied to both sides of the Left & Right Stabilizer Abrasion. These rolls are approximate 6' long. Please verify that the parts are correct for your Cessna model/year by referring to the applicable Cessna parts manual prior to ordering. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Product is what was needed .. thanks
Cessna Boot 1232040-5
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Approx 3/32"
Per vendor, yes, that can be used on a 206.
This is made of neoprene.
This boot material is 6 inches in width.
These are no longer have the sticky backing, they would need to be glued down.
It is not pre-formed, it is a flat rubber material.
Per vendor: We recommend 1300L.
Per notes on the web, Note: Per aircraft, a quantity of two boots needs to be applied to both sides of the Left & Right Stabilizer Abrasion. These rolls are approximate 6' long.
0332136-6 has been superseded to 1232040-5.