Part No. | Outside Dia. | Material | Color | Temp Rate |
---|---|---|---|---|
11-16882 | 1/2" | PTFE | Natural | -449°F to +500°F |
**Note: Less 10% discount for 100 FT. (per size)**
Permits flexible routing of cable harness while forming a neat, protective bundle. It twists on easily and quickly and allows lead-outs at any point. When installed, it may be gapped for greater economy and flexibility or it may be butted tightly for maximum abrasion resistance, insulation protection and greater rigidity. Nylon type-for use in wider temperature ranges with high resistance to abrasion and good solvent resistance. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Very good durability and resistance to higher temperatures. This has been the perfect solution to our issue of lines dragging over hot and rough surfaces
Spiral Wrap 1/2 Natural Teflon Ptfe
Spiral Wrap 1/2 Natural Teflon Ptfe
I dont know how another customer could have made such a negative post regarding spiral wrap, especially if it was PFTE (Teflon), which I have found to be of excellent performance and withstands engine compartment heat year after year, with no degradation whatsoever
Great service, fast shipping. I would definitely buy from Aircraft Spruce again and/recommend this company. Thanks!
Spiral wrap tubing works great for bundling wires in the cockpit, along the floor and behind the panel. Makes for easy organization of wires. Highly recommended.
service was fast and will be ordering again, thanks
Product was as ordered. Seeing the size gave me insight as to what I needed to order next time.
Low cost way to add safety reserve to your airplane. These eliminate chafing concerns and provide a removable way to neatly bundle wires without ty-wraps or lacing. They can also protect fuel and vacuum lines. I was able to install some one-handed without undue difficulty in a hard to access area.
Product is great, but the size chart shown is mis-leading. The max. diameter is not the diameter of the wire bundle, but something else.
Started using it on panel upgrades instead of wires. Gives the final product a more professional look
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Unfortunately no, this product is not FAA approved for an over heat condition.
The 3/4", our p/n 11-12334, is approx. .550".
Temp range is -4*F to +176*F. There are different ratings depending on specific part number you choose.
You would want the 1/4 one.
The 1/2 OD has an .37 id, that would probably be the best option.