71685 Series LED Recognition/Landing light assembly. No FAA Approval. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Brightness should be OK, but not yet mounted, only tested.
Whelen LED Light 01-0771685-01
Great replacement for Ductworks lead edge landing lights LID lamps....fits perfectly!
Whelen LED Light 01-0771685-01
Small, lightweight, easy installation and surprisingly bright. No noise, well designed. 1 amp v 12 amps for an incandescent. Whelen never disappoints.
Very easy to install. Not as bright as some led landing lights but I find it sufficient.
I bought two of these as replacements for an E-LSA. Since the design was different than the original lights I had to trim and modify the backplate to get these to fit. The light output is sufficient and the price is good. No noise in the radio during operation. There are more powerful Whelen LEDs but at double the cost
Disappointed with the very low intensity and will be looking for a replacement. The 24V version that was installed in my plane actually cut out below 26V (usually right after landing when going to engine idle!) and needed to be replaced by the manufacturer.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The amperage is listed in the Drawing And Specifications Sheet listed as a PDF in the 'Documents' tab of this web page. Please review the specs there.
Per the manufacturer the lumen output on P/N 11-11189 is 10k candle power.
No, the Whelen 71685 series does not have any FAA Approval.
Yes, these can run on 12v or 14v systems.
Yes, The 01-0771685-01 can be flashed. They can utilize any type of aircraft flasher, we would recommend something like the maxpulse system. Part number 11-06998.