Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Grip, Right Hand 1
MFR Model# 100R100PTT
FREE Shipping
| Description | Grip | Bore | Part No. |
|---|---|---|---|
| Grip, Right Hand 1” | Right | 1" Bore | 11-01020-1 |
Overview
|
These homebuilt control grips are made of high-strength urethane plastic, finish painted in matte black and come complete with all necessary hardware (AN screw, nut, washers). Available unbored or bored to accept 7/8”, 1”, or 1-1/8” diameter tubing. All grips (except unbored) are available with or without PTT switch. Add -1 to the part number for PTT. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Reviews
Nice product. They look good, feel good and work great. The only thing I didnt like is they arent bored very deep. I had to cut a couple inches off my control sticks.
Verified Purchase
Grip, Right Hand 1
Verified Purchase
Grip, Right Hand 1
Verified Purchase
Grip, Right Hand 1
Verified Purchase
Grip, Right Hand 1
Finishing and polishing not 5 stars
Very angry Switch wires were broken and fell out when opening the package and the switch did not work. the switch wires are too heavy gauge and would have broken when they were coiled inside the grip for transport. I will be writing to the manufacture to voice my anger at such poor work. Stay clear. RV6 owner.
Verified Purchase
Grip, Right Hand 1
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it can be done. The PTT button has bare wires hanging out the bottom of the grip, so the builder or avionics shop would need to hook the bare wires up to the PTT switch wires on the Icom radio. This would be a custom installation. There are no adapters to go straight from the grip to the Icom handheld.
1. Yes, the wires will come out of the bore hole in the bottom of the grip.
2. Yes, the PTT button can be pushed in with the thumb on the models that include the PTT switch.
3. Yes, the PTT button is the only button protruding from the stick on the models with PTT switch.
Overall height of the grip is approximately 4-1/2". Bore depth is approximately 1-1/2".
The grip that you reference slips onto the control stick. There is a hole on the side for securing the grip to the control stick and it would require drilling into the stick to fasten the screw. The PTT switch can be replaced.