|
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
I accidentally duplicated my order and the customer service folks were very helpful, since I had not opened the second order they refunded my purchase without a restocking fee. The replacement switch fit perfectly and works perfectly.
TCM Switch 10-357290-1
I purchased the 10-357210-1 which does not have a start function just L, R, Both and OFF mag positions. The switch performs well as an FAA certified mag switch in a 1946 Aeronca 7AC champ. I had to build a mount plate because the switch mounts on the left side between the front and rear pilot seats and it was about 7/8 too deep to go in the space between the aircraft fabric surface and the switch mounting plate. The switch did not come with a certification form so I entered the TCM part number as an FAA approved switch in the airframe log book.
TCM Switch 10-357290-1
Looks great, was very easy to install. I had an older switch that was smaller, so I did have to enlarge the hole to 7/8 to accommodate this switch, but that was easily and cleanly done with a taper bit.
TCM Switch 10-357290-1
Excellent service as usual !
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this switch is certified.
The switch itself is FAA-PMA'd. There is no applicability list. That must be determined by the installer but it is FAA Approved for use in certified aircraft.
Per the installation manual: 1.068 x 1.828
10-126690-1 superseded to 10-357200-1
It is rated to handle magneto primary voltage and/or 24 volts DC, 5 amps.
These are single sided keys per the data sheet.
12 months or 500 hours, whichever happens first.
The key can only be removed in the off position.