Wing Walk compound worked very well. I cleaned the worn walk area with dish soap and water rinse - then let dry. Then carefully taped the perimeter with blue painters tape and was careful to push the tape down real well to avoid any paint-creep onto the adjoining white paint on the plane. I then stirred the compound for about 15 minutes...its got alot of hard packed sand on the bottom of the can - it does eventually blend in...I promise! I then applied the compound to the wing walk with a 3 inch roller which worked very well. After about 30 minutes of drying, I then held my breathe and pulled off the painters tape and hope I ended up with clean, crisp lines. The end result worked out well fortunately.

Superior Product: I applied it to the entire rear bumper (blue) cover of a 2001 Eurovan to match the black swing arm and box/bike carrier. I sanded it with 80 grit paper and applied 2 coats 48 hours apart. The result is perfect in every way. Then I sprayed thin coat of clear satin lacquer to minimize indication of abrasion. Finished, it looks like a black vinyl and one quart cost $45 landed versus $850 to paint the number.

Good quality paint, easy to apply.

Great product, easy to use. I brushed it on. It is very important to stir it very often, the grit settles faster than ya would expect. When the grit starts to settle the brush gets more paint than grit. Just dip the brush approx 1 inch, dab and brush small areas, stir repeat.

Took a little bit to stir up but worked fine.

Great Product

Very good product and easy to apply , just make sure you DON’T use a brush as directed, it’s messy and doesn’t spread product evenly (tends to lump if too much paint applied ) . Save your money and buy a cheap paint kit at Walmart (small roller handle, roller , and small pan) and roll away, and you will be done in less than 20 minutes per coat. Wait 24 hours between coats. The hardest part is mixing the product, all the grit settles at the bottom and it takes a lot of stirring effect to get it all mixed together. I did it by hand but I’d recommend a mixing tool with a power drill to save time!!!

Takes time to finish cure. Dont step on it for a few days. Be sure to put on in thin even coats. Let dry several hours between coats. Dont continue to brush once applied or it can lump and smear. If this happens. Scape off clean up and start over. You will only do this once. Looks very nice when finished

used over previous wing walk compound after brush application i went over with a small roller..flawless finish

Great paint. Very difficult to mix up. All the grit settles to the bottom and is hard to remix.

Robert K Verified Purchase

Randolph X-1567G Wing Walk Compound Gray Mil-W-5044 Type 2 Gallon

I have not used any other product but this works as advertised. As others have said, you have to keep stirring it when in the can. I had stored the can upside down for a couple of months after I had received it. Regardless, the grit was still a near solid lump sticking to the can bottom. I used a good painters stick to break the lump up but once broken up, the grit mixed in with the liquid but does not remain suspended for more than a couple of minutes so keep mixing while using the paint. The top of the liquid in the can was about 3/4 shy of the top of the can but I presume that this is normal. PB Blaster works to get the paint off your hands. As suggested, use throw away brushes and a small paint roller.