Simple design for push-pull operation with low friction characteristics. Has .050" dia. stainless steel wire core in flexible metal casing with polyethylene liner. May be shortened as required. Max. travel 3-1/2". Features a black powder coated aluminum T-handle. Made in USA |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Works great
After 62 years the starter cable on my 1958 Cessna 172 broke. I replaced it with this one and am confident it will last even longer than the original. I like the smoothness when I pull to start (Teflon coated on the inside). I like the metal T-handle (better than plastic). All in all a great product from a great supplier of quality aircraft parts. Thank You Lloyd
T-Handle was just what I was looking for. Works well on my C140. Replaced my starter pull. On needed a 3 foot length . Your customer service rep could not find it in your catalog??? I had to thumb through An old Spruce catalog to find it and call again with item number.
Cable is not as the one pictured the T bar handle is bet around on either side. Looks kinda hokey compared to the picture
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The approximate dimensions for the knob on this control are: 2-1/4" Length x 1/2" Width x 1-1/8" protrusion from dash.
The wire's diameter is .05" O.D. The casing is 3/16".
The T-Handle is threaded and put on with loctite. The loctite can be "broken" with a torch but that may possibly damage the T-Handle and the control.
The thread is 3/8-24 so you will need to drill a 3/8" hole in your panel to fit this through.