MC0411257 A universal joint attaches to each control yoke shaft behind the instrument panel. Slack or roughness in control yoke motion commonly indicates excess universal joint wear or corrosion that may necessitate replacement. Includes protective sleeve.
|
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
The factory part had the AN3 holes about 1/32 farther apart, so a washer in the washer stack that makes the yoke not click when you push and pull (sets the clearance) had to be replaced with a thinner one for it all to fit. I recommend having/buying some 1/2 inch aircraft washers if you buy this. This was on a 172G from 1966.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, Cessna 210 serial numbers 57001 through 57575 are eligible. Also, 210A serials 21057576 through 21057840.
The weight is approximately 0.12 lbs.