Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Eaton Aeroquip Firesleeve AE102-9
MFR Model# AE102-9
FREE Shipping
|
Aeroquip P/N | I.D. | Clamp (See Accessories) | Use With Hose #303 | Use With Hose #601 | Our P/N |
|---|---|---|---|---|---|
| AE102-9 | 9/16 | 900591B-2C | -4 | -5 | 05-01843 |
Overview
|
Aeroquip Firesleeve was specially developed to meet the fire resistance requirements of FAATSO - C53a OR TSO - C75. May be used for all fuel, oil, hydraulic, fire extinguisher & propeller feathering lines. "Fire-proof" hose lines as defined by FAA must withstand a direct flame for fifteen minutes under specified flow conditions without failure. Fire-resistant lines must withstand a 5-minute exposure under these conditions. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Documents
Reviews
Works great
Verified Purchase
Eaton Aeroquip Firesleeve AE102-9
Bought this size based on chart recommendation for hose it fits over.
Verified Purchase
Eaton Aeroquip Firesleeve AE102-9
Just what I needed
Great product!
Great service as usual
High quality & finishing.
This item fits and works great. The inside is soft and will flex when the hose sides into the fire sleeve. I just cut with scissors the full length of hose with fittings on and this will cover any bends of your hose. If sleeve is to long just push back and the slack will go back down the hose and still look great. One thing I found when installing the sleeve on a long hose was to use a long air blow tube from the air compressor line and insert it down the hose between the fire sleeve and the hose that the fittings are already on. I found that the blow tube should be on the end of the sleeve in the direction of travel. Blow air and just side the sleeve up the hose with now problem. I also used plugs at both ends to keep contamination out of the hose
Too expensive
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These Aeroquip fire sleeves are priced and sold by the foot.
Per the dims, AE102-8 fire sleeve would fit.
