Description | Part No. |
---|---|
Music wire 32 gauge .090 | 03-49600 |
This is a fairly high-grade, high-carbon steel wireto specification ASTM A-228. It is a “cleaner” steel than hard drawn and exhibits a better fatigue life. Today, music wire is made by either direct drawing from rod or lead patenting. As a guide, most stocked music wire thicker than 0.0625" is more likely to have been direct drawn. Although very high in tensile strength, must be capable of wrapping around itself without showing signs of cracking. 156 ft. of .049" dia. wire per lb. 22Ga., 46 ft. of .090" dia. wire, per lb. 32 Ga. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
courteous, effective communication. rapid delivery of product as described
Not too hard to work with (to bend) and regular wire cutters will cut it. I used up about 4 feet (plus another 4 feet in mistakes) to make the four baffle spring fasteners for my inter-cylinder baffles. This page: http://n140tw.blogspot.com/2013/11/baffle-spring-fastener-wires.html helped me make the fasteners. But minimum purchase is one full pound which for the 22 gauge gives you 156 feet of wire. So I have nearly 150 feet of wire left over. Would be nice if sold by the half-pound.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This is a solid wire.
Yes, it can be used as an inner wire
It is not stocked on pre-cut one pound lengths. If you place an order for 5 pounds, it will be one piece at 5 lbs.