FREE SHIPPING ON ORDERS OVER $350 (SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

1015/1020 Bush 1/2 X.065 - 3 Foot

$35.85/Each
Part# 03-16900-3
MFR Model# 250MIN
O.D. (In.)I.D. (In.)WallPart No.
1/23/8.06503-16900-3

Overview



Seamless mechanical tubing may be used either statically or dynamically. Its close tolerance, good finish and dense structure make it ideal for parts such as shafts, bushings, bearings, etc. Tensile strength 80,000 PSI. Drill or ream for proper bolt fit.

If manufacturing test reports are required, there is a minimum $15.00 charge per order. Please indicate in the special instructions box at the time of order that certs are required.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Everything is on spot with your service. Shipping could be lowered some but other then that items are top quality!

David G
May 3, 2020

High quality precise dimensions

Dan O
April 2, 2020

Fast shipping and just what I needed thinks

Wilburn
January 19, 2020

I use this stuff all the time. Terrific bushing stock. Commons sizes and easy to ream to nice fit on the I.D.

Dave R
January 19, 2019

Good quality but had to be drilled out to size.

Jim P Verified Purchase

1015/1020 Bush 1/2 X.065 - 3 Foot

December 9, 2023

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What material is this bushing stock?

It is 1020 steel.

Q: The dimensions listed must be off. 3/8 id + .065 wall = .44 od (not .5). What are the correct dimensions?

The website is correct and we measured our stock. When doing the math you have to double the wall because you will lose .065 on both sides of the "ID."

View in Catalog

View Image View in Catalog