Lord round instrument panel shock mount, as used in Cessna aircraft. Overall length 1-1/4". Rubber molded on 8-32 threaded projections. New manufacture. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Lord Round Instrument Panel Shock Mount J6984-8
Perfect - item as advertised and delivery was quick
Lord Round Instrument Panel Shock Mount J6984-8
Lord mounts were installed within three hours after the delivery. Everything OK, fits as expected. Much more better, even the price comparing with noname products
Lord Round Instrument Panel Shock Mount J6984-8
Over priced. By 300 %
Lord Round Instrument Panel Shock Mount J6984-8
These rubbers made my panel wiggle again!
Lord Round Instrument Panel Shock Mount J6984-8
These seem pretty flimsy for the price, I wish they made ones that had a little more meat to them.
Lord Round Instrument Panel Shock Mount J6984-8
Lord Round Instrument Panel Shock Mount J6984-8
I have done a full replacement of this part on 4 Cessna (C185, 2 C172s and a C210. I am about to do another C172. I trust this product most of all because of its sturdy and solid build. It will take a long time before it becomes a problem like the OEM that youre replacing.
Lord Round Instrument Panel Shock Mount J6984-8
Arrived on time and as ordered.
Lord Round Instrument Panel Shock Mount J6984-8
I replace 6 broken instrument panel lord shock mounts and the new 1s were just like the old 1s but not broken
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The rubber section is approximately 1/2 inch long.
For shock mount part number 10-14700 the rubber has a diameter of .4"
Yes, these are non-magnetic.
No, the nuts are sold separately.
There is not a specific nut and washer that it calls for but it is threaded 8-32. An365-832a and an960-8 would work.