Spring Loaded Switch Guards. Klixon switch guards can be used with 2 or 3 position switches. Covers are molded out of Thermoset molding materials. Guard covers are spring loaded to close. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Looks good, however I haven’t installed it yet.
Phenolic Red Switch Guard 3 Pos
Phenolic Red Switch Guard 3 Pos
These are great for covering three-position rectifier switches in guitar amps, but closing the cover still moves the bat to the middle position. I use a dremel to rout enough clearance so the switch stays where I put it.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
When closed, the switch can only be in the off position.
The diameter of the hole is .459 inches.
No, they are spring loaded to remain closed.
This is not keyed per the vendor.
Yes, this should fit that toggle.
Per Manufacturer: "8499K1, MS25452-1 Safran (Labinal Power Systems / Eaton Aerospace) toggle switch guard, Qualified to MIL-G-7703 & MS25452-1,Flush Mount for 2 Position Full Throw Switches, Permits locking toggle in extreme up position, Metal Green Lever."