Always know the support is there when needed

Chris B Verified Purchase

Cherry Equivalent Ccp-42 SsD42-Ssbs

I never have enough. Use them for tons of stuff on my home built and non-aviation stuff. The -42s are the most common length I use. I buy hundreds of them and am always surprised when I run out!

Dane R Verified Purchase

Cherry Equivalent Ccp-42 SsD42-Ssbs

finally a good quality rivet

Fast service, and the item I needed. Thank you for keeping stock up, especially in these interesting times.

It was delivered reasonably quick. Very much appreciated.

worked great

Worked as advertised

perfect

Comon guys... Their S/S Cherry Rivets, and they work as advertised.

These rivets were quite riveting.

Very good rivet. I was concerned tensile strength was too high for thin fiberglass cowling, but I was wrong. With 120 degree, there is still adequate thickness in countersink and install is flawless.

Excellent, just as ordered

This worked very well in the hand riveter I in an aluminum boat structural modification.

Great for nutplates

Excellent service.

Spruce shipped promptly and the rivets pulled and popped like expected.

Good quality. All pulled nice. No duds

These small countersunk pop rivets are handy for mounting nut plates. The countersink angle (82, 100,degrees?) is not mentioned on your web page but it should be.

Quality rivet pulls smoothly and makes a solid connection.

arrived ok

Good quality of rivet.

This specialty rivet was the only one that met my requirements. The serviced in sending it was excellent. The job is done. Thanks.

Rivet length is as described however, the rivet does not sit flush in the countersink.

Everything else in the order was spot on, perhaps qty a few in excess of what I ordered, BUT this item came as 14 of what I wanted and 6 assorted other rivets, either shorter or different head type. It is understandable. As the rivets are restocked, they go in the wrong bin. They all look the same when they fall on the floor!!!! Lucky for me I ordered some extras. Keep up the good work, and good luck keeping those bins sorted :-)

I placed this order in September 2019 and just received it in January. I understand backorders happen but the only status info I had was when I went to the website and looked at the status. I would expect email updates as the back order dates changed, which it did several times. Secondly, I was charged shipping on the first part of my order and again on this back ordered portion. Not having the part in stock is not my fault and the shipping should be waived.

The rivets are fine, but dont confuse these for MK-319. They are a different size.

My good condition rivet gun would not grip the smooth stems