This unique tool for 1/8" 120° countersunk "Pop" rivets attaches to the Cherry G-28 standard hand "Pop" rivet gun. Simple design makes dimpling foolproof, quick and easy, with no cracking of metal. For use on aluminum to .040" thickness. Made in USA |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
The dimpling tool is well crafted, durable and easy to use.
120Deg. Flush Dimpling Tool 17014
Used this on .050 aluminum sheet. The supplied nails only lasted for two pulls. I switched to steel nails which were more durable. Thankfully this tool is setup for that. I was very satisfied with the results
120Deg. Flush Dimpling Tool 17014
Well worth the price. Works perfectly and simple to use.
120Deg. Flush Dimpling Tool 17014
works great for all those hard to reach places
120Deg. Flush Dimpling Tool 17014
Product worked great
Handy little tool. Especially for hard to get to place for the big dimpler
Instructions say to attach male die to rivet gun. It has the wrong threads for the 4 guns I own. Makes a nice dimple if you treat it as just a rivet.
120Deg. Flush Dimpling Tool 17014
This tool is only designed to be used with the G-28 tool which is over $120. The thread size of the dimplier fitting is not the same size as a hardware riveting tool . It will not fit into your hardware riveting hand tool. Other than that, tool looks to be well made. I have not actually used it because I dont have the G-28 tool. I feel ACS should also make a version with the proper thread size to fit into ordinary rivet hand tools.
Doesnt fit my pop riveter. I was looking for a 120° dimple and this was it. I now see another one with no angle spec that is more universal, a 12-01179.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, its designed to be used with a pop rivet tool.
The 17014 was designed to be used with a G-28 pull type rivet gun, which one of the dies is threaded to fit the gun, and the 12-01179 can be used with any pull type rivet gun, it does not have a threaded die, it just has a straight shank mandrel that goes in the rivet gun like a mandrel on a pull type rivet.