Description | Part Number |
---|---|
1" Aircraft Punch & Flare Tool Set | 12-02778 |
Just drill a pilot hole for the 1/2 inch draw bolt, apply the tool and tighten the bolt for a smooth, flared hole in one easy step. Punch hole only by removing female flare ring and use punch and die. Easily mounts in Mittler bench presses. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
These things are the best, we got a 1 inch punch and flare to make lighting holes for Barron sheetmetal repair and it performs flawlessly. Will probably end up getting other sizes for my homebuilt project.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.