Size 3/16 - straight shank straight flute chucking reamer - high speed steel |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
High Spd St Chuck Reamer 3/16
Had to ream out some holes on a frame that was painted . Worked well.
High Spd St Chuck Reamer 3/16
A nice addition to my tools. Not often needed, but now when I need it I have it.
High Spd St Chuck Reamer 3/16
Sharp and straight at a good price. It made a beautiful hole and the screw fit perfectly (snug).
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
AN3 is a #10 bolt, so a #10 reamer should be used. 3/16" would also work, but not as close a tolerance as #10. The part number for the #10 reamer is 12-02468.