Worked exactly as advertised. Very satisfied. I would buy it again.

Louis V Verified Purchase

Bogert Flat Pivot Point Jack Pad

WOW what a great tool. Made my PM of the bearings so easy!

Alfonso C Verified Purchase

Bogert Flat Pivot Point Jack Pad

Great tool that is well designed. The cap that comes with it fits on most bottle jacks and makes a good secure jack point.

Richard A Verified Purchase

Bogert Flat Pivot Point Jack Pad

Best jack pad on the mkt

Roy P Verified Purchase

Bogert Flat Pivot Point Jack Pad

Does the job really good! Nice to have one in your hangar.

Arien Verified Purchase

Bogert Flat Pivot Point Jack Pad

Work perfectly on my Mustang II

Bertrand G Verified Purchase

Bogert Flat Pivot Point Jack Pad

Well made and as advertised.

Fred T Verified Purchase

Bogert Flat Pivot Point Jack Pad

Easy to install. Holds in place until its removed. Made jacking the plane up to change bearing a breeze.

I made my own similar to this. I just wanted to recommend the use of a piece of leather between the jack and the gear leg. It slips less and protects the gear leg paint

The ends are not high enough, does not encompass the strut on a 172 with the wrap on it.

Product along with any bottle jack will not accomplish job. May seem inconsequential, but the product description should state 1. Additional C-Clamp for safety restraint required. 2. Bottle Jack head must be approximately but not to exceed 1 3/16 for swivel head to be secured. 3. Use caution while jacking for weight shift movement of remaining gear points. My bottle jack would not safely accommodate the swivel head due to size so I had to track down another jack. 5/8 Wrench & 11/16 Wrench or socket required for tool fitment. Additional Allen Wrench required for Swivel Head attachment. Instruction also suggests lining tool to prevent marring of Landing Gear. In all, caused delay getting all the proper pieces assembled.

It works ok on later 172s with the flatter gear, with a C clamp, but that is hard on the paint. But on early 172s all 180/185 and 188 gear legs, the slant of the gear is so steep that it slips right off, I tried using a C clamp, but even that did not work. I dont recommend it.

Hand made tool did not work as described needs for C clamp extra, as never sit in it place Worth for $25 not more