Excellent product, ready for work right out of the box. Very well made and engineered. Superior to the Tempest product.

Trevor T Verified Purchase

Airwolf Can Cutter AFC-470-R

Works great. I had zero need for a vise held the filter in one hand and turned the cutter with the other. Taking small bites with the cutter wheel yields stellar results. Highly recommend.

Best filter cutter hands down. I wouldn’t consider buying a different one.

Bob A Verified Purchase

Airwolf Can Cutter AFC-470-R

Well built, made in the USA which is rare these days. Works flawlessly.

Robert M Verified Purchase

Airwolf Can Cutter AFC-470-R

This oil filter or equivalent is essential for examining aircraft oil filters for evidence of engine wear.

John C Verified Purchase

Airwolf Can Cutter AFC-470-R

No surprises here - works as designed.

Integrity A Verified Purchase

Airwolf Can Cutter AFC-470-R

Solid and well made. Easy to use, even without a vice to hold the filter.

Robert S Verified Purchase

Airwolf Can Cutter AFC-470-R

Work great.

Gary G Verified Purchase

Airwolf Can Cutter AFC-470-R

Took it down to the shop hanger. My IA is jealous now!

Michael R Verified Purchase

Airwolf Can Cutter AFC-470-R

Works great! Well made and its made in the USA!

Excellent piece of gear. Arrived late due to back order. Well built.

Seems well made. Have not had the chance to use it yet, but certainly looks up to the task.

Works well, better than expected.

Well built and easy to use. Turned with my hand till cut through.

Cuts the filter cans easily, is well made and one of the nicest features is that if you put a piece of tape over the hole in the bottom of the tool base it contains any residual oil from the filter after cutting it open so it doesnt make a frigging mess everytime you use it.

I have tried less expensive cutters, this one is by far the best.

This cutter is excellent. It is far better than the last one I had. Easy to use and well built, I expect it to last a lifetime. I would definitely recommend it.

Best solution around for cutting filter cans. Price was right, service immediate

Easy to use and works well.

Works well and well made.

This works great. I dont have a vice in my hangar, so I put a large 1 wrench on the filter, lay it on the floor with the filter facing up, and hold the wrench in place with my knee. Then you just spin the tool around the filter, tightening it a bit each time around. After 3 or 4 times around, its cut all the way through.

The instructions say to use a vise to hold the filter in place while you rotate the filter cutter. As I dont have a vise, I simply held the filter in one hand and adjusted the filter cutter and turned it with the other hand. That technique worked just fine the cutting blade is sharp enough to not provide much resistance. Its a well made product that does its job well.

I used the oil filter cutter and it worked very well. My reason for not giving a 5 star rating, it would have been nice if it had storage case. Mark Hogan Pilot/A&P