Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Got Your Six Mic Covers
MFR Model# GY6-MICCOVER
FREE Shipping
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
|
Keep your headset mic clean! Trim to fit almost everymicrophone out there including David Clark M7 and M4, Lightspeed, Bose, Telex, and everything else we tried.Once trimmed to length, carefully grab the headset mic muff coveron both sides and pull it down gently into place. Will stay in place on it's own. The o-ring is not necessary with our product - oursfit snugly and stay in place. The O-ring design is inferior from David Clark because if the o-ring splits, their mic cover falls off immediately. Not ours! Headset mic covers for David Clark, Bose, Lightspeed, etc should be replaced annually for santary purposes, plus they help maintain the microphone quality - if the mic cover fails, moisture and dirt can then reach your microphone, which is an EXPENSIVE part. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Reviews
Cover fit my David Clark mic perfectly. This was a good purchase at a reasonable price.
Verified Purchase
Got Your Six Mic Covers
Fits well over the microphone on the Bose X and does what it is supposed to do. Quite a bit larger than the original, which doesnt have any practical downside, other than with certain mic positions, you can see it out of the corner of your eye.
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
