Description | PN | L4C | L4F | L6C | L6F | RTX | J22 | J33 | RTXiS |
---|---|---|---|---|---|---|---|---|---|
EGT, 0.75-1.25" Hose Clamp | 10-01844 | - | - | - | - | 2 | - | - | - |
Dynon Avionics engine sensors, harnesses & packages. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Exelent product !!!! Work very good !!!
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Very nice
Dynon EGT Sensor Hose Clamp .75 - 1.25 Rotax
Just what I needed. Contained the whole unit (probe, clamp, wires with connectors).
Great unit easy to install. extra pins include in case you mess up.
If your Dynon PFD shows a RED X before start up on the CHT , replace the sensor. ACS had plenty in stock simple replacement and the fixed the temp. display prob.
Great response...no problems!
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
As supplied by Dynon Avionics, this (and all other "Kavlico" sensors) do come with a connector and wires.
Yes, part # 10-01168 is sold by the foot.
This probe is directly from Dynon.
Part # 10-01169 is priced and sold individually.
This is a pinned out connector harness with thermocouple wires inserted in the connector. No probes are included.
No, p/n:10-01847 is just the harness. For the probe you can view p/n: 10-01844.
This is the sender with a clamp.
It is 0.1 inch.
Probe wire length is 24 inches, the EGT/CHT harness from the skyview is 6 feet.