This is a great product! Work very well better than anything I’ve ever used. Put’s a mirror look after just 2 polishing. If you have and airplane, mag wheels, Airstream RV it’s the right stuff !!! Bert Clearwater FL

Albert Verified Purchase

Met-All 1 Lb.

works great

Tim R Verified Purchase

Met-All 1 Lb.

Works as good as the 50 dollar polish on my old 140

Greg B Verified Purchase

Met-All 1 Lb.

This is a fantastic product. Using it to polish all my brass …candlesticks,etc. they have never look this good. Amazing polish. Thank you!!!!

Patricia D Verified Purchase

Met-All 1 Lb.

Very satisfied with this polish.

Great aluminum polish. Us it on my propeller spinners. Recommend you use a buffer or electric drill with a small sponge buffer wheel. Much quicker with better results. However, can was badly dented upon delivery. Shipping cardboard box looked fine with no damage but can was dented so bad that it will eventually leak.

Very good product. Works very well in removing aluminum oxide from parts over 30 years old.

This is the best aluminum polishing product that I have tried and I have tried a bunch of them. It isnt magic, easy, but it works the best of those I have tried. on severely stained bare aluminum. It slings off the pad the least, too. This is a big help. A useful tip: when you fail to clean up every little bit of the black residue from polishing, it turns black and rock hard (same as all the rest of the polishes), you can get it off with WD-40 rather easily!

I was surprised. For many years, I have been using a cotton wadding to polish the spinner but decided to purchase the MET.ALL as the wadding was seeming to be too much work and really did not do that good a job. To my surprise, with the MET.ALL, it only took a few minutes to shine up the rain spotted and time dulled spinner. MET.ALL has a light smooth paste consistency closer to honey than peanut butter. I agree with the above - have lots of cotton rags available as they get black fast.

A very good polish that will give your trim work a deep shine. We have been using this for over 10 years and brings many compliments from the customers. Continually use a new section of the polishing cloth to avoid rubbing the black oxidation back into the work piece. We Finish the polishing work with a light wax to repel water and keep the deep shine longer. If you use this on the heated intakes/exhaust stacks, spray alcohol/water mix onto the wax after buffing to remove any silicone from the wax. The heat from the intakes will cause the silicone to stain the polishing work otherwise.