Application | Part No. |
---|---|
0/IO-470, IO-520, IO-550A, B, C (6 Cylinder) | 08-01323 |
These seals from Real Gasket Corp. provide 37% more sealing area at the point of contact with the pushrod tube, and vector spring pressure by its beveled top and companion washer. FAA Approved for the Continental engines shown below. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Just what was needed to stop my oil leaks in the tcm io360
purchased the kit for an IO 360 Followed real gaskets install instructions...Ran the engine, flew the plane, they leaked. I cleaned engine and they kept leaking... took a 4 trip and everyone of them leak !! Now, doing the job over again with factory seals !! NEVER AGAIN will I use Real Gaskets !! I only gave them 1 star because they were at least gaskets.
I bought the full set for my IO-360 to fix those pesky oil leaks. During install, I noticed even with the rubber seal stretched over the push rod tube, it wasn’t nearly as tight sealing in the engine block. The original OLD seals fit tighter!!! I called the company that made the kit and they explained that this is normal and the spring would help expand the rubber in the block.... NO DICE. They all leak. We have to do the job again and we will be buying the original seals from continental. Why would this “upgraded” kit fit so loose... The company explained the rubber parts are ordered in bulk from CHINA by the thousands.. must have got a bad batch. Do not waste your time with this kit. The old rubber seals do a better job... Bis kit was installed on a 1979 Cessna hawk XP...
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, comes with qty 2 seals, qty 2 washers, and qty 2 o-rings.
You would want our part number 08-01326 for that engine. These are FAA PMA'd.