Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Matco Brake Fluid Reservoir
MFR Model# MCR-100
FREE Shipping
- JUMP TO
- Overview
- Documents
- Reviews
- Q&A
- View in Catalog
Overview
|
This brake fluid reservoir
from Matco features a clear plastic bowl for easy inspection
of reservoir fluid. Furnished with pre-drilled aluminum flange
for easy mounting.Small and compact, this reservoir mounts almost
anywhere. Reservoir only P/N 06-11225 Reservoir Kit P/N 06-11230 (includes reservoir, tubing, and fittings for installation) |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Documents
- Parts Breakdown (PDF)
- Drawing/Dimensions (PDF)
Reviews
Verified Purchase
Matco Brake Fluid Reservoir
good quality
Verified Purchase
Matco Brake Fluid Reservoir
I purchased the reservoir and the reservoir kit. The reservoir that I received did not have a 1/8 NPT port as described but a 1/8 flare fitting and the kit came with a 1/8 NPT fitting that does not fit. The thread at the reservoir is BSPP, standard parallel pipe, the other end is UNF-2B not 1/8 NPT.
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the manufacturer, yes this should be plenty large enough.
The total length is approximately 4.5".
Per the supplier: Yes. It is commonly mounted on the engine side of the firewall. However, it should not be in close proximity to a direct heat source.
The female NPT threads would be located on the bottom of the unit.
Per Vendor: It should be mounted using the bracket. Some desire to mount it using only the fittings to support it and that is not desired means to secure it. It is also vulnerable to inadvertent contact in that location as well.
This is made of polycarbonate material so it will not work with those fluids. This is made to work with H-5606 hydraulic fluid.
Yes, part # 06-11225 will come as shown in the photo.
The 06-11230 kit comes with fittings for up to two master cyliinders.
The base adapter fitting female side is 1/8 NPT as stated.
The cap has a vent hole in it. It is under the bracket with space provided by the washer separating the cap from the bracket.
