Description | Part Number |
---|---|
CESSNA REAR PLATE FOR 172 I, K, L, M, N, & P | 05-07290 |
NOTE:Cessna 172 Spinner Dome PN 05-09045 will not work for 1960 Cessna 172A. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Fits perfectly my C172L. Rapid service to complete my annual - thanks Aircraft Spruce Canada
Cessna C172 Spinner Rear Plate
Still in the box i have to paint it then install it
Cessna C172 Spinner Rear Plate
Every hole lined up perfectly Looks good
Aft Bulkhead for spinner on Cessna 172M. The part was what I needed and it was installed by A/P. Quality and fit were good.
Very nice aft spinner bulkhead. It is manufactuered from one piece of aluminum and not two or three riveted plates like the OEM part.
spinner and bulkhead for a cessna 182
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
15" height X 11-1/4" base diameter.
Yes, these spinners are FAA PMA approved.
Yes, this will include the backplate in the kit.
The forward plate is a plastic piece that has no holes drilled into it.
Yes, it is PMA'd. And yes, it has the nutplates installed.
We have added this photo to the web page.
9.75"
No the back plate is not included.
Yes it is our part number 05-09035.
P/N: 05-07275 has drilled holes but doesn't have installed nutplates or screws included.