Injection molded ABS plastic fairings used to cover hole in airframe where control cables emerge such as the rudder cables at the rear of the fuselage. May be installed on any airframe surface but is most normally used on fabric covered aircraft where they are bonded on with fabric cement and covered with a fabric patch. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Control Cable Fairings
Great service fast turnaround time!
Control Cable Fairings
I wanted 3 pieces, ended up with 6 not stated they were 2 ea. Not a big deal but.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The height dimension you are looking for is approximately 1-3/16". The unit is shipped closed so you will need to do your own cut out.
Length = 5" / Width (Middle) = 1-3/8"
The fairing at the widest point has an ID of 0.40" and at the smallest width is 0.35".