Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
T-88 Building Glue 1 Gal
MFR Model# 1100K24
FREE Shipping
- JUMP TO
- Overview
- Documents
- Reviews
- Q&A
- View in Catalog
Overview
|
Note: Two part system, quantities will be combined amount of part A and part B. For example, for the gallon size, part A will be 1/2 gallon and part B will be 1/2 gallon totaling 1 gallon. T-88 is a non-brittle structural adhesive which gives superior finished results even when used under adverse working conditions. T-88 will cure in temperatures as low as 35°F which makes it an excellent choice for homebuilders living in colder climates. It is recommended by the builders of many types of homebuilt aircraft and is excellent for bonding aluminum, steel or wood. When fully cured, it is not affected by water, oil, gasoline and most other chemicals. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Documents
- Tech Data Sheet (PDF)
Reviews
The glue is fine but Iv not recieved the entire order
Ideal product for applying to prepared aluminum prior to bonding with fiberglass. A selection of quantity sizes makes it a cost-effective solution.
2nd order, works great for what I do.
This is a great product works as advertised
Works very well for it’s purpose
awsum,
Amazing structural epoxy I can see why so many recommend it for aircraft use. I will now always have some available.
Been using T-88 since around 1970. (Long before Aircraft Spruce marketed it.) Always got good wood tear on compressive shear coupons.
Excellent product excellent service
Did not want to run out of glue with the pandemic, would have gone mad with nothing to do. Once again you came through on time and well packed. thank you....
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the manufacturer: There is no shelf life for this product. Shelf life is indefinite.
It is an open top container.
The ratio is 1 to 1, resin to hardener.
Both the 1/2 pint and 1 pint sizes are packaged as pictured.
Per supplier: approximatley 25 sq ft.
You just need to make sure the surface is clean and smooth. Our guess is you are using a self-etching primer, like zinc-chromate, or zinc-oxide. T-88 should work fine over that as long as the prep is done properly for those primers was done correctly.
This material doesn't have any information how well it works on titanium, but does work well with aluminum.
It does cure clear, but may have a cloudy look if used in large quantities.
It will bond aluminum and styrofoam, they recommend clean etched aluminum. Once cured it is not elastic but also not brittle so it will have some flex. As for working time they recommend starting off with small 2-3oz batches that would have a 30 minute or so pot life. The larger the batch the shorter the pot life so it is better to mix multiple batches rather than one large batch.
It can be used with fiberglass but it is fairly thick and would not flow. It would need to be applied with a spatula type device.
