Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
|
These cone spring hooks and
locking rings are used as terminal fasteners. Insert cord through
small end of cone. Apply and crimp locking ring about 1/2"
from end of cord, pull cord back until locking ring contacts
inside of fastener. Cut ends of cord may be sealed by dipping
in rubber cement. Quantity 1 |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Reviews
Good quality.
Verified Purchase
Shock Cord Fastener 1/2 Set
Verified Purchase
Shock Cord Fastener 1/2 Set
Verified Purchase
Shock Cord Fastener 1/2 Set
Think about selling the rings separately without the springs. For some reason I thought you did
These fasteners are cheap!! They are not of the same quality as older ones uses on ski rigging. Installed a new set of 1/2” recently but both failed at the crimp. Had to modify to make them work. I have replaced my share of bungees and never had issues with the old style fasteners. Built much better quality. Little 1/4” ones seem to be ok but doesn’t. take the same load
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
