Whelen Model A610 flash tube glass lens are used for installing wing tip strobes in single engine Cessna's 1972 and later. The existing position light retainer is modified to accommodate the lens, and the flash tube is mounted directly behind. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Miss on the molex connector type, but was easy to de-pin and set new pins on the old connector. Great storbe lights!
Whelen A610M Strobe Tube Assembly - Molex Connector
Ordered the light with the molex connecter. Removed three screws securing the old light and installed the new light. Turned on the battery and beacon switch to check it out and no problem. It worked well and very bright.
Whelen A610M Strobe Tube Assembly - Molex Connector
Whelen A610 Strobe Tube Assembly
Exact part I needed. Arrived promptly. Shipping was a little pricy
Whelen A610 Strobe Tube Assembly
Whelen A610 Strobe Tube Assembly
As described, perfect fit & function, and very prompt shipping. Top marks!
Whelen A610 Strobe Tube Assembly
Whelen A610 Strobe Tube Assembly
Whelen A610 Strobe Tube Assembly
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes the "M" means that the molex connector is included.
Just the connectors at the end of the wire leads. A610 has the standard rectangle connector as seen in the first photo, and the A610m has the molex connector shown in the second photo.
Yes, the A610 has a standard square connector, and the A610M will have a molex.
This must be wired through a Whelen power supply. The power supply can be installed in both 14 and 28 volt systems.