Overview

	WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

To Use & Maintain

• Stir or mix well as ingredients may settle overtime
• Calculate how much oil you need for your project based on wood species or surface material. Remember a little Odie’s goes a long way, do not over apply! Apply sparingly with a non woven pad (rated equal to or just higher than your last sanding grit) and work the oil into the surface using circular motions. The friction from the application process helps to loosen up and drive the oil into the surface.
• Once the finish has been thoroughly worked into the surface, allow to set up for approximately 10 minutes to 3 hours, depending on the surface applied to (45-60 minutes typically being the ideal time for wood) For surfaces like leather, metal, plastic, stone, epoxy and concrete, you can buff off almost immediately after application. Do not allow the product to set for more than 8- 10 hours, this may result in a reapplication with Odie’s Universal Oil to reactivate the finish for a proper buff/wipe off.
• Now it’s time to Buff Off and remove any and all excess/residual oil from the surface until dry to touch. Take a clean terry cotton towel and scrub the surface clean, making sure to regularly flip to a clean section of towel as it gets loaded up with oil. Switch to a clean towel if/when needed. If you can swipe a clean finger across the surface without leaving a mark, you are done!
• Most surfaces can be handled almost immediately and lightly used within 24-48 hrs. Please allow 3-5 days cure time before being subjected to standing liquids.
• Additional coats of your favorite Odysseus Cornwall’s finish, Odie’s Universal Oil, Odie’s Wood Butter or Mr. Cornwall’s Super Duper Everlasting Oil can be applied using the same easy steps as above. We recommend waiting a day between coats with the exception of Odie’s Waxes, if top coating with Odie’s waxes, ideally, we recommend 3-5 days cure time.
• For non porous surfaces like epoxy resin, metal, stone and polished concrete much less oil is needed in the application process, please see coverage metrics.

• The typical Odie’s Universal Oil finished floor will easily perform for 10-15+ years with regular cleaning and care before ever needing any maintenance. The only way to wear the finish away is to wear the surface away itself. If and when the time comes for some maintenance, whether it’s your floor, a countertop, tabletop or cutting board etc., simply clean the surface (check out to clean your Odie’s treated surfaces here) and apply another light coat of your desired choice of Odysseus Cornwall’s finish as per their instructions. For exterior projects, maintenance will depend on the direct exposure to the elements and the products originally used to finish the project. In extreme conditions, maintenance could be once a year to once every several years or longer in normal conditions.

Specifications

• 9 oz & 32 oz reusable glass jars

Coverage Metric

• Approximately 21-25+ Sq. Ft per oz on typical domestic hardwoods (ie: cherry, walnut, maple, oak).
• Approximately 14-18+ Sq. Ft per oz on softwoods (ie: cedar, pine, fir).
• Up to 35-50+ Sq. Ft per oz on dense exotic hardwoods (ie: rosewood, purpleheart, Brazilian walnut, jatoba).
• Anywhere from 50-100 Sq. Ft per oz on concrete depending on level of polish.
• Approximately 35-50 Sq. Ft per oz on metal depending on surface texture.
• Approximately 35+ Sq. Ft per oz on epoxy.