ICOM A220 MBA-3 Rear Panel Adapter. For installation into a card edge connector equipment including PS-80. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Some tips on disconnecting and re-connecting the multi-wire connector would be helpful.
Icom MbA3 A220 Rear Panel Adapter
As advertised. Used for installation of A220 into A200 tray. Verify the pin out of the tray to the needs of the A220. There may be some extra connections on the A200 tray.
Icom MbA3 A220 Rear Panel Adapter
Does the job. Easy and no problems. New radio in older PS-80. Perfect
Icom MbA3 A220 Rear Panel Adapter
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
THE Icom MBA3 Rear Panel Adapter with card edge connector fits the Icom A220. The MBA3 allows A220 to fit into a panel mount previously occupied by King KY96A, KY97A, KY196A, KY197A.
This MBA3 will require soldering and additional assembly. It is not plug and play. Per the manufacturer it will allow the unit to be retrofitted into the A200
The correct adapter needed will be an MBA-3/11-14470.