1-877-4-SPRUCE | info@aircraftspruce.com
Aircraft Spruce & Specialty Co.
 
 
THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-4-SPRUCE
Home / Airframe Parts / Cessna Parts / Fairings /Cessna Brake Line Fairing Extrusion
Main Image
Main Image
Thumbs 1
Thumbs 1

Cessna Brake Line Fairing Extrusion

4 Reviews 1 Answered Question
Select Size:
Per Foot5 Ft Section
Quantity
Add to Wishlist

Overview

Cessna Brake Line Fairing Extrusion.
Reduce drag!
  • Paintable
  • Easily attaches with super glue
  • Sold in 5 ft lengths / by the foot
  • Replaces P/N S1511-1
White rubber extrusion that attaches to the trailing edge of flat Cessna landing gears and serves as a fairing for the brake line.

This extrusion was original equipment on later model aircraft with flat gears. Many mechanics use this as an improvement for the earlier aircraft.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Submit a Review

Hal L Verified Purchase

Cessna Brake Line Fairing Extrusion 5Ft
December 20, 2024

Bought a set of these for my 170. Used gorilla glue, which may not have been the best, but worked well enough. Held in place with blue or green painters tape. Have been flying with them for a year or more now. I like the product enough that I am buying more for my new gear legs.

William B
March 23, 2021

Great stuff, relatively quick and easy to install. Took my time and still got it done in a couple of hours. I used Loctite, gel type super glue. Starting at the top of the gear leg I applied drops of the glue in two rows to the leg and used blue masking tape crosswise the fairing every couple of inches to hold it while the glue set, working alternately side to side.

Louie H
May 3, 2020

Not easy too install. I attempted SuperGlue as directions suggested. Did NOT work. Do NOT recommend

Kent W
March 14, 2019

Q&A

Submit

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What size is the groove for the brake line to sit in? Will it fit 1/4 hard line?

Width: 11/16 | Height:9/16 | Round groove cut: 7/32 or .232 | Middle width: 9/16 | Groove cut to top height: 1/8