SAFETY FOOT STOP SEAT RESTRAINT FOR CESSNAS

An AD was precipitated by a number of incidents where the pilot lost control of the aircraft due to the sudden and rapid aft movement of the seat when the pin disengaged from the seat rail due to excessive wear of the seat  rail holes. Cessna has now issued a SEB07-5A to address this problem making compliance mandatory. Safety Foot Stop is different in that it is integral with the existing seat lever. Should the pin not engage in a rail hole, thereby having the pin set on top of the rail, this device will still prevent the seat from moving aft.   Safety Foot Stop is similar to a doorstop, linked to the seat lever by a mechanical arm arrangement. Lifting the seat lever to allow the maximum up position and with a light rock forward will disengage the Safety Foot thereby allowing the seat to be positioned as required. Releasing the seat lever to its lowest position will re-engage the Safety Foot. The FAA has issued a "No Hazard Installation Approval" for this system since it will augment safety only, and is not considered part of the airframe or engine so it doesn't require a "337" or an STC, therefore it can be Owner/Operator installed. The system will in no way eliminate the requirement for good rails and pins, it just provides an additional measure of safety in single engine Cessna aircraft. The Safety Foot Stop is currently under Patent Applied For. The Safety Foot Stop kit comes complete with all required hardware and detailed instructions. The average installation time is approximately one hour per seat.

Description Part No. Price Buy SAFETY FOOT STOP 05-03390 $189.50

Similar Items Part No. Price Buy SAF-T-STOP (PAIR) + 13-18510 $37.50